机器概述 本機為经典型攪拌機，附兩支攪拌混合刀片。適用於印刷電路板油墨，導光板油墨，導電銀膠、碳浆，一般油墨塗料之攪拌混合调色，亦可作感光乳劑之攪拌。 操作說明 1、將本攪拌機平放於平台上,插上電源前,請先檢查電壓是否為220V,確定無誤後方可插入電源插座,此時紅色電源指示燈會點亮。 2、將欲攪拌之油墨放置於旋轉盤的固定夾上，若使用IKG之小塑膠罐時，另有輔助夾可供使用，確認油墨固定好之後方可放入攪拌刀。 3、開啟電源啟動開關，旋轉盤開始轉動，轉速為0~150轉／分，可依油墨性質自由選擇調節轉速。 4、本機亦有時間控制之裝置，使用者可依油墨之粘度自由選擇控制攪拌時間。 技術參數 型 號 ISM-01A 攪拌容量 1L~5L 時間控制 0~60分鍾 轉 速 0~150轉/分 電 源 220V 50HZ 重 量 21kg 機械尺寸 L320*W230*H600mm
Machine this This machine is of the typical mixer, with two mixing blade. Apply to printed circuit board printing ink, reflex the ink, the conductive silver glue, carbon pulp, ink coating commonly the mixing toning, may also be the mixing of photographic emulsions. Operation explanation 1, will the mixer which lie flat on the stage, before plugged in, please check whether the voltage is 220 V, determine the correct the power supply socket, this time the red power instructions will light up. 2, will want to stir the ink in place of rotating disc clamp, if use IKG small plastic cans, otherwise auxiliary clip available, confirm ink fixed may in the bowl after knife. 3 and open power start switch, rotating disc begin to turn, the rotating speed is 0 ~ 150 RPM, by printing ink nature free choice regulate speed. 4, this machine is also a time of the control device, users can depend on the free choice control viscosity ink mixing time. Technology parameters Type,
ISM-A Mixing capacity
1 L ~ 5 L Time control
0 ~ 60 minutes Turn speed
0 ~ 150 r/min Electricity source
220 V frequency 50 HZ Heavy quantity
21 kg Mechanical size
L320* W230*H600mm
15720909537
